ДАТЧИК ДЕТОНАЦИИ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock control sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of throttle body with motor assembly	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here
Cleaning the deposits from the throttle body with motor assembly	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here
Replacement of battery	Switch battery type	Stop and Start System	Click here

PROCEDURE

REMOVE INTAKE MANIFOLD

Click here
REMOVE KNOCK CONTROL SENSOR
1. Disconnect the knock control sensor connector.
2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.
  
  Note
  
  If the knock control sensor has been struck or dropped, replace it.