REAR SEAT OUTER BELT ASSEMBLY(for Wagon) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY LH

    A004NMT

    1. Align the claw with the anchor bracket positioning hole and install the anchor bracket with the 2 bolts.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

    A004Q5Y

    1. Align the claw with the 3 point type belt positioning guide and install the 3 point type belt with the nut.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  4. INSTALL INNER ROOF SIDE GARNISH CAP LH

    Click here

  5. INSTALL BACK DOOR WEATHERSTRIP

    Click here

  6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  8. INSTALL REAR FLOOR FINISH PLATE

    Click here

  9. INSTALL DECK FLOOR BOX LH

    Click here

  10. INSTALL ROPE HOOK ASSEMBLY (w/o Deck Rail)

    Click here

  11. INSTALL NO. 6 DECK SIDE TRIM COVER (w/o Deck Rail)

    Click here

  12. INSTALL NO. 2 DECK SIDE TRIM COVER (w/o Deck Rail)

    Click here

  13. INSTALL FLOOR SIDE RAIL LH (w/ Deck Rail)

    Click here

  14. INSTALL REAR DECK FLOOR BOX

    Click here

  15. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  16. INSTALL DECK BOARD SUB-ASSEMBLY

    Click here

  17. INSTALL DECK BOARD ASSEMBLY

    Click here

  18. INSTALL LOWER DECK TRIM SIDE BOARD LH (w/ Partition Board)

    Click here

  19. INSTALL ROOM PARTITION NET ASSEMBLY (w/ Partition Board)

    Click here

  20. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  21. INSTALL REAR SIDE SEATBACK ASSEMBLY LH

    A004RMW

    1. Install the claw as shown in the illustration.

    2. Install the side seatback with the bolt.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }
    3. A004RC9E02
      Text in Illustration
      *1 Protruding Part

      Install the rear seat 3 point type belt anchor with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

      Note

      Do not allow the anchor part of the rear seat 3 point type belt to overlap the protruding parts of the floor panel.

    4. Install the seat belt to the belt guide.

    5. Attach the claw to close the cap of the rear seat shoulder belt guide.

    6. Check if the ELR locks.

      Note

      The check should be performed with the outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  22. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here