AIR FUEL RATIO SENSOR(for Sensor 2) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of air fuel ratio sensor (sensor 2)

  • Gas leak from exhaust system is repaired

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here (w/ Canister Pump Module)

Click here (w/o Canister Pump Module)

PROCEDURE


  1. REMOVE AIR FUEL RATIO SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

    B0083FX

    1. B0084XS

      Disengage the wire harness clamp.

    2. Disconnect the air fuel ratio sensor connector.

    3. B006YBPN01

      Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

      SST
      09224-00012

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.