NAVIGATION SYSTEM(for Sedan) Microphone Circuit between Radio Receiver and Extension Module

DTC Code DTC Name
Microphone Circuit between Radio Receiver and Extension Module

DESCRIPTION

This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.

Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

WIRING DIAGRAM

E277822E02

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)

    1. Disconnect the V6 radio and display receiver assembly connector.

    2. Disconnect the V5 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      V6-5 (MIC+) - V5-16 (MIC+)

      Always

      Below 1 Ω

      V6-6 (MIC-) - V5-17 (MIC-)

      Always

      Below 1 Ω

      V6-1 (SLD4) - V5-18 (MSHLD)

      Always

      Below 1 Ω

      V6-5 (MIC+) - Body ground

      Always

      10 kΩ or higher

      V6-6 (MIC-) - Body ground

      Always

      10 kΩ or higher

      V6-1 (SLD4) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR