THEFT DETERRENT SYSTEM Horn Circuit

DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the body ECU transmits a signal to cause the horn to sound at intervals of 0.4 seconds.

WIRING DIAGRAM

B0028Y1E03

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • w/ Door Control Battery:

    As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.

    Click here

  • w/ Automatic Light Control System:

    If the body ECU has been replaced, it is necessary to initialize the body ECU.

    Click here

PROCEDURE


  1. INSPECT HORN


    1. Press the horn switch and check if the horn sounds.

      Result
      Result Proceed to
      Horn sounds A
      Horn does not sound B

    B

    GO TO HORN SYSTEM Click here

    A

  2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. Remove the body ECU.


    2. Disconnect the instrument panel junction block assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      B00284RC14
      *a Component without harness connected (Instrument Panel Junction Block Assembly) - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      2D-14 - A-9 (HORN) Always Below 1 Ω
      Result
      Proceed to
      OK (for LHD)
      OK (for RHD)
      NG (for LHD)
      NG (for RHD)

    OK (for LHD)

    REPLACE BODY ECU Click here

    OK (for RHD)

    REPLACE BODY ECU Click here

    NG (for LHD)

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Click here

    NG (for RHD)

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Click here