TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 8 Sensor Type)

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the TOYOTA parking assist-sensor system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Result

    Proceed to

    NEXT
    NEXT

  3. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the ignition switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT
    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*

    1. Use the GTS to check if the CAN communication system is functioning normally.

    Result

    Result

    Proceed to

    CAN communication system DTCs are not output

    A

    CAN communication system DTCs are output (for LHD)

    B

    CAN communication system DTCs are output (for RHD)

    C
    B

    GO TO CAN COMMUNICATION SYSTEM

    Click here

    C

    GO TO CAN COMMUNICATION SYSTEM

    Click here

    A

  5. PROBLEM SYMPTOM CONFIRMATION

    Result

    Proceed to

    NEXT
    NEXT

  6. CHECK DTC*

    1. Check for DTCs.

      Click here

    Result

    Result

    Proceed to

    DTC is output

    A

    DTC is not output (Problem symptom does not occur)

    B

    DTC is not output (Problem symptom occurs)

    C
    B

    SYMPTOM SIMULATIONClick here

    C

    PROBLEM SYMPTOMS TABLEClick here

    A

  7. DIAGNOSTIC TROUBLE CODE CHART

    1. Refer to Diagnostic Trouble Code Chart.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

    CIRCUIT INSPECTIONClick here

  8. SYMPTOM SIMULATION

    1. Refer to Symptom Simulation.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  9. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click here

    Result

    Result

    Proceed to

    Fault is not listed in problem symptoms table

    A

    Fault is listed in problem symptoms table

    B
    B

    CIRCUIT INSPECTIONClick here

    A

  10. OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Operation Check

      Click here

    2. Terminals of ECU

      Click here

    3. Data List / Active Test

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  11. CIRCUIT INSPECTION

    1. Adjust, repair or replace as necessary.

    Result

    Proceed to

    NEXT
    NEXT

  12. IDENTIFICATION OF PROBLEM

    Result

    Proceed to

    NEXT
    NEXT

  13. REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  14. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END