REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR AIRBAG SENSOR

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      B296256C01

      *a

      Correct

      *b

      Incorrect

    4. Insert the pin (stopper) into the body hole and install the rear airbag sensor to the vehicle body with the nut.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:

      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    5. Connect the connector to the rear airbag sensor.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      1. Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

        C198070C07

        *1

        White Housing Lock

        -

        -

        *a

        Slide

        -

        -
        Tip:

        When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an insecure connection.

    6. Check that there is no looseness in the installed parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE GARNISH

    Click here

  3. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY

    Click here

  4. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

  5. INSTALL REAR DOOR SCUFF PLATE

    Click here

  6. INSTALL REAR SEATBACK ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. INSPECT SRS WARNING LIGHT

    Click here