STEERING PAD INSTALLATION

PROCEDURE

1. INSTALL HORN BUTTON ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Text in Illustration

      *1	Airbag Connector
      *2	Horn Connector
      *3	Airbag Connector Lock

      Connect the airbag connector to the horn button assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the airbag connector lock to install the airbag connector.

   5. Connect the horn connector to the horn button assembly.

   6. 

      Push the horn button assembly to engage the 2 pins.

      Note

      
      

      • Make sure that the pins are securely inserted into the steering holes.

      • Make sure that the horn button assembly is securely installed.

2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

   
   

   1. 

      Engage the claw to install the lower No. 3 steering wheel cover.

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

   
   

   1. 

      Engage the claw to install the lower No. 2 steering wheel cover.

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. INSTALL DECK FLOOR BOX RH

   Click here

6. INSTALL REAR DECK FLOOR BOX

   Click here

7. INSTALL NO. 1 DECK BOARD

   Click here

8. INSTALL NO. 2 DECK BOARD

   Click here

9. INSTALL DECK BOARD ASSEMBLY

   Click here

10. INSPECT HORN BUTTON ASSEMBLY

    
    

    1. Make sure that the horn sounds.

       If the horn does not sound, inspect the horn system Click here.

11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

12. INSPECT SRS WARNING LIGHT

    Click here