QUARTER GARNISH REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL NO. 2 REAR PILLAR GARNISH PROTECTOR

    Tech Tips

    When installing the No. 2 rear pillar garnish protector, heat the quarter pillar cover sub-assembly using a heat light.

    Heating Temperature
    Item Temperature
    Quarter Pillar Cover Sub-assembly 20 to 30°C (68 to 86°F)

    Note

    Do not heat the quarter pillar cover sub-assembly excessively.


    1. Clean the quarter pillar cover sub-assembly surface.


      1. Using a heat light, heat the quarter pillar cover sub-assembly surface.

      2. Remove the double-sided tape from the quarter pillar cover sub-assembly.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Using a heat light, heat the quarter pillar cover sub-assembly.

    3. Remove the release paper from a new No. 2 rear pillar garnish protector.

      Tech Tips

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    4. for TMMT Made:


      1. B008L6CC01
        *a Line

        Install the No. 2 rear pillar garnish protector as shown in the illustration.

        Tech Tips

        Install each No. 2 rear pillar garnish protector along the line on the quarter pillar cover sub-assembly.

    5. for TMC Made:


      1. B008MGVC01
        *a Mark-off Line
        *b 2.0 mm (0.0787 in.)

        Install the No. 2 rear pillar garnish protector as shown in the illustration.

        Tech Tips

        Align each No. 2 rear pillar garnish protector with the mark-off line of the quarter pillar cover sub-assembly.

  2. INSTALL QUARTER GARNISH MOULDING (for TMC Made)

    Tech Tips

    When installing the quarter garnish moulding, heat the quarter pillar cover sub-assembly using a heat light.

    Heating Temperature
    Item Temperature
    Quarter Pillar Cover Sub-assembly 20 to 30°C (68 to 86°F)

    Note

    Do not heat the quarter pillar cover sub-assembly excessively.


    1. Clean the quarter pillar cover sub-assembly surface.


      1. Using a heat light, heat the quarter pillar cover sub-assembly surface.

      2. Remove the double-sided tape from the quarter pillar cover sub-assembly.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Using a heat light, heat the quarter pillar cover sub-assembly.

    3. Remove the release paper from a new quarter garnish moulding.

      Tech Tips

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    4. B008L90C01
      *a Line

      Install the quarter garnish moulding as shown in the illustration.

      Tech Tips

      Install each quarter garnish moulding along the line on the quarter pillar cover sub-assembly.