TILT SENSOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE FRONT SEAT ASSEMBLY LH

    1. for Manual Seat:

      Click here

    2. for Power Seat:

      Click here

  4. REMOVE COWL SIDE TRIM BOARD LH

    Click hereClick hereClick here

  5. REMOVE FRONT DOOR SCUFF PLATE LH

    Click hereClick hereClick here

  6. REMOVE REAR DOOR SCUFF PLATE LH

    Click hereClick here

  7. REMOVE OUTER LAP BELT ANCHOR COVER

    Click hereClick here

  8. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click hereClick here

  9. REMOVE YAW RATE SENSOR BRACKET

    1. Partially remove the floor carpet.

    2. E266957

      Remove the bolt.

    3. Detach the guide and remove the yaw rate sensor bracket.

  10. REMOVE YAW RATE SENSOR ASSEMBLY

    1. E266958

      Disconnect the connector.

    2. Remove the 2 bolts and yaw rate sensor assembly.

      Note:

      Do not remove the yaw rate sensor assembly sensor from the bracket.