DYNAMIC REAR STEERING SYSTEM TEST MODE PROCEDURE


  1. TEST MODE


    1. Activate Test Mode.


      1. Turn the engine switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Turn the GTS on.

      5. Enter the following menus: Chassis / DRS / Utility / Check Mode.


        Chassis > DRS > Utility
        Tester Display
        Check Mode

    2. Check the Test Mode display.


      1. Check that "DRS TEST MODE" is displayed on the multi-information display when the system enters Test Mode.

    3. End Test Mode.


      1. Switch the system from test mode to normal mode by following the directions on the GTS screen.

      2. Turn the engine switch off.

      3. Disconnect the GTS to the DLC3.