TRANSMISSION WIRE INSTALLATION


  1. INSTALL TRANSMISSION WIRE

    A01E043

    1. Coat a new O-ring with the ATF, and install it to the transmission wire connector.

    2. Install the transmission wire with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the transmission wire connector.

  2. CONNECT TRANSMISSION WIRE

    A01DYKME02

    1. Connect the 7 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.42 in.) for bolt B

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01DUXAE01

    1. Coat a new O-ring with ATF and install it to the oil strainer.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01E1YUE01

    Tech Tips

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install a new gasket and the oil pan with the 20 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  5. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR (for 1KD-FTV)

    A01DVPCE01

    1. Install the engine mounting insulator to the transmission with the 4 bolts.

      Torque:
      47 N*m  { 479 kgf*cm, 35 ft.*lbf }

  6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)

    A01E2FL

    1. Install the frame crossmember to the engine mounting insulator with the 4 set bolts.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf }

    2. Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.

  8. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  9. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.