POP UP HOOD ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL PEDESTRIAN DETECTION ECU ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B006BY6

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If this procedure is performed without disconnecting the negative (-) battery terminal of the battery, the pop up hood lifter may deploy even if an impact is applied only to the pedestrian detection ECU assembly. Therefore, make sure that the negative (-) battery terminal of the battery is disconnected before performing this procedure.

    3. B006EQRC01
      *a Water Resistant Sheet
      B006DHE Lock in this Direction

      Check if the water resistant sheet is not torn or peeled off.

    4. Install the pedestrian detection ECU assembly with 2 new nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • Do not reuse the pedestrian detection ECU assembly if subjected to any strong impact (such as dropping) during operation.

      • When the engine switch is first turned on (IG) after the pedestrian detection ECU assembly has been replaced, make sure that no one is in the vehicle.

      • Do not reuse the nut.

    5. Connect the connector and lock it with the lock lever.

      Note

      Do not allow the water resistant sheet to become pinched.

    6. Check that there is no looseness in the installed pedestrian detection ECU assembly.

    7. for RHD:


      1. B006CG6

        Return the No. 1 console box duct to its original position.

      2. B006CYA

        Install the 2 clips.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here