ДАТЧИК ДЕТОНАЦИИ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock control sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

Replacement of throttle body with motor assembly Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

Cleaning the deposits from the throttle body with motor assembly

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE KNOCK CONTROL SENSOR


    1. B006RB7

      Disconnect the knock control sensor connector.

    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.

      Note

      If the knock control sensor has been struck or dropped, replace it.