DOOR CONTROL RECEIVER(w/ Tire Pressure Warning System) REMOVAL

CAUTION / NOTICE / HINT

Click here

PROCEDURE

1. REMOVE DECK BOARD ASSEMBLY

   Click here

2. REMOVE NO. 1 DECK BOARD

   Click here

3. REMOVE NO. 2 DECK BOARD

   Click here

4. REMOVE REAR DECK FLOOR BOX

   Click here

5. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

   Click here

6. REMOVE BACK DOOR SCUFF PLATE

   Click here

7. REMOVE REAR DOOR SCUFF PLATE LH

   Click here

8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

   Click here

9. REMOVE REAR NO. 2 SEAT ASSEMBLY

   Click here

10. REMOVE NO. 1 DECK TRIM COVER

    Click here

11. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

12. REMOVE FRONT DECK SIDE TRIM COVER LH

    Click here

13. REMOVE NO. 2 CUP HOLDER

    Click here

14. REMOVE NO. 2 ROOM LIGHT ASSEMBLY

    Click here

15. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

    Click here

16. DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Lower Side)

    Click here

17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

18. DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Upper Side)

    Click here

19. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click here

20. REMOVE ELECTRICAL KEY AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY

    Note

    
    

    • Do not drop, strike or otherwise subject the electrical key and tire pressure monitoring system receiver assembly to impact.

    • If the key and tire pressure monitoring system receiver assembly is subjected to an impact, replace it with a new one.

    
    

    1. 

       Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the 2 guides and remove the electrical key and tire pressure monitoring system receiver assembly.