TURN SIGNAL FLASHER ASSEMBLY(for LHD) ON-VEHICLE INSPECTION

PROCEDURE

  1. CHECK TURN SIGNAL FLASHER ASSEMBLY

    1. Measure the resistance according to the value(s) in the table below.

      U123745E02
      U123746E02

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      DE-2 (GND) - Body ground

      Always

      Below 1 Ω

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection

      Condition

      Specified Condition

      DA-28 (LR) - DE-2 (GND)

      Hazard warning switch off

      Below 1 V

      Hazard warning switch on

      Alternates between 11 to 14 V and below 1 V

      (60 to 120 times per minute)

      DA-27 (LL) - DE-2 (GND)

      Hazard warning switch off

      Below 1 V

      Hazard warning switch on

      Alternates between 11 to 14 V and below 1 V

      (60 to 120 times per minute)

      DB-32 (+B) - DE-2 (GND)

      Always

      11 to 14 V

      DS-11 (EL) - DE-2 (GND)

      Ignition switch ON

      Headlight dimmer switch (turn left) off

      9 V or higher

      Ignition switch ON

      Headlight dimmer switch (turn left) on

      Below 1 V

      DS-12 (ER) - DE-2 (GND)

      Ignition switch ON

      Headlight dimmer switch (turn right) off

      9 V or higher

      Ignition switch ON

      Headlight dimmer switch (turn right) on

      Below 1 V

      DS-17 (HAZ) - DE-2 (GND)

      Hazard warning switch off

      9 V or higher

      Hazard warning switch on

      Below 1 V

      If the result is not as specified, there may be a malfunction in the turn signal flasher.