REAR STABILIZER BAR INSTALLATION

PROCEDURE


  1. INSTALL REAR STABILIZER BAR BUSHING (for LH Side)


    1. A004JUWE02
      Text in Illustration
      *1 Rear Stabilizer Bar Bushing
      *a Stopper Ring

      Install the rear stabilizer bar bushing to the outside of the stopper ring on the rear stabilizer bar as shown in the illustration.

  2. INSTALL REAR STABILIZER BAR BUSHING (for RH Side)

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL REAR STABILIZER BAR


    1. Install the rear stabilizer bar to the rear suspension member.

  4. INSTALL REAR STABILIZER BRACKET (for LH Side)


    1. A004IO6E02
      Text in Illustration
      *a Crow

      Install the rear stabilizer bracket with the 2 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Install the rear stabilizer bracket with its claw facing upper.

  5. INSTALL REAR STABILIZER BRACKET (for RH Side)

    Tech Tips

    Use the same procedure described for the LH side.

  6. INSTALL STABILIZER LINK SUB-ASSEMBLY (for LH Side)


    1. Install the rear stabilizer link sub-assembly to the rear stabilizer bar

    2. Using a socket hexagon 5 mm, hold the stud bolt and tighten the nut.

      Torque:
      38 N*m  { 388 kgf*cm, 28 ft.*lbf }

    3. Temporarily install the rear stabilizer link sub-assembly to the rear No. 2 suspension arm assembly LH with the bolt and a new nut.

  7. INSTALL STABILIZER LINK SUB-ASSEMBLY (for RH Side)

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)

    Click here

  9. INSTALL REAR WHEELS

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  10. STABILIZE SUSPENSION

  11. FULLY TIGHTEN STABILIZER LINK SUB-ASSEMBLY (for LH Side)


    1. Install the rear stabilizer link sub-assembly to the rear No. 2 suspension arm assembly LH with the bolt and nut.

      Torque:
      38 N*m  { 388 kgf*cm, 28 ft.*lbf }

  12. FULLY TIGHTEN STABILIZER LINK SUB-ASSEMBLY (for RH Side)

    Tech Tips

    Use the same procedure described for the LH side.

  13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  14. VSC SENSOR NEUTRAL MEMORIZATION

    Click here

  15. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

    Click here

  16. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)

    Click here