LIN COMMUNICATION SYSTEM PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name

    See Procedure

    Stop and Start System

    Click here

    Simple Intelligent Parking Assist System

    Power Door Lock Control System

  2. PRECAUTIONS WHEN USING GTS

    1. When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

    2. After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the ignition switch is turned to ON.

  3. IGNITION SWITCH EXPRESSIONS

    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch (Position)

      Engine Switch (Condition)

      Ignition Switch off

      LOCK

      Off (Lock)

      Ignition Switch ACC

      ACC

      On (ACC)

      Ignition Switch ON

      ON

      On (IG)

      Engine Start

      START

      On (Start)