CRAWL SWITCH INSPECTION

PROCEDURE

  1. INSPECT COMBINATION SWITCH ASSEMBLY (CRAWL CONTROL SWITCH)

    1. C219807C02

      *1

      Speed Selector Switch

      *2

      ON/OFF Switch

      *a

      Component without harness connected

      (Combination Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      5 (UP) - 9 (E)

      SPEED (UP): Pressed

      Below 1 Ω

      SPEED (UP): Not Pressed

      10 kΩ or higher

      3 (DN) - 9 (E)

      SPEED (DOWN): Pressed

      Below 1 Ω

      SPEED (DOWN): Not Pressed

      10 kΩ or higher

      6 (ECU) - 9 (E)

      ON/OFF: Pressed

      Below 1 Ω

      ON/OFF: Not pressed

      10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly (crawl control switch).