FRONT DOOR LOCK INSTALLATION

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

    Click here

  3. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)

    Click here

  4. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

    Click here

  5. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

    Click here

  6. INSTALL FRONT DOOR LOCK COVER SUB-ASSEMBLY (w/o Double Locking System)

    Click here

  7. INSTALL FRONT DOOR LOCK ASSEMBLY

    Note


    • When reusing a removed front door lock assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock assembly.


    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. When reusing the front door lock assembly:


      1. Install a new door lock wiring harness seal to the front door lock assembly.

    3. A005CWCE04
      Text in Illustration
      *1 Front Door Lock Open Rod

      Connect the front door lock open rod to the front door lock assembly.

      Tech Tips

      Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    4. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    5. Connect the connector.

  8. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  9. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  10. INSTALL FRONT DOOR GLASS RUN

    Click here

  11. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  12. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  13. INSTALL FRONT DOOR TRIM BRACKET

    Click here

  14. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  15. INSTALL DOOR ARMREST COVER

    Click here

  16. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  17. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  18. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  20. INSTALL DECK FLOOR BOX RH

    Click here

  21. INSTALL REAR DECK FLOOR BOX

    Click here

  22. INSTALL NO. 1 DECK BOARD

    Click here

  23. INSTALL NO. 2 DECK BOARD

    Click here

  24. INSTALL DECK BOARD ASSEMBLY

    Click here

  25. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  26. INSPECT POWER WINDOW OPERATION

    Click here