REAR TURN SIGNAL LIGHT BULB REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR LIGHT COVER

    Click here

  2. DISCONNECT REAR COMBINATION LIGHT ASSEMBLY


    1. B007WRXC01
      B007ZL6 Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. B007YG1

      Remove the 2 screws.

    3. B007WSDC01
      *a Pin
      *b Guide
      B007Z37 Remove in this Direction

      Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.

      Note

      To prevent the rear combination light assembly from falling when disengaging the pin, lightly hold the rear combination light assembly.

  3. REMOVE REAR TURN SIGNAL LIGHT BULB


    1. B007ZAAC01
      B007Z37 Remove in this Direction

      Turn the rear light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

    2. Remove the rear turn signal light bulb from the rear light socket and wire.

  4. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. Install a new rear turn signal light bulb to the rear light socket and wire.

    2. B007WZKC01
      B007Z37 Install in this Direction

      Turn the rear light socket and wire with the rear turn signal light bulb as shown in the illustration to connect them as a unit.

  5. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    1. B007YMJC01
      *a Pin
      *b Guide
      B007Z37 Install in this Direction

      Engage the 3 guides and pin to temporarily install the rear combination light assembly as shown in the illustration.

    2. Install the rear combination light assembly with the 2 screws.

    3. Remove the protective tape.

  6. INSTALL REAR LIGHT COVER

    Click here