ЗАДНЯЯ ПЛАНЕТАРНАЯ ПЕРЕДАЧА ПОВТОРНАЯ СБОРКА


  1. INSTALL REAR PLANETARY RING GEAR FLANGE


    1. B007T8S

      Install the ring gear flange.

    2. Using a screwdriver, install the snap ring.

  2. INSTALL REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING


    1. B007TOHE02

      Coat the races and the bearing with petroleum jelly, and install them onto the rear planetary ring gear.

      Races and bearing diameter:
      Inside Outside
      Race (A) 28.5 mm (1.122 in.) 44.2 mm (1.740 in.)
      Assembled Bearing and Race (B) 27.7 mm (1.091 in.) 44.2 mm (1.740 in.)

  3. INSTALL PLANETARY CARRIER THRUST WASHER NO.1


    1. B007UWI

      Coat the thrust washer with petroleum jelly.

    2. Install the thrust washer No.1 onto both sides of the rear planetary gear.

      Tech Tips

      Make sure that the lug shapes fit into the cutout portions of the rear planetary gear.

  4. INSTALL PLANETARY CARRIER THRUST WASHER NO.2


    1. B007S5B

      Coat the thrust washer with petroleum jelly.

    2. Install the thrust washer No.2 onto both sides of the rear planetary gear.

      Tech Tips

      Make sure that the lug shapes fit into the cutout portions of the rear planetary gear.

  5. INSTALL 1 WAY CLUTCH NO.2


    1. B007SYYE02

      Install the one-way clutch and 2 retainers into the rear planetary gear.

      Tech Tips

      Make sure that the open ends of the guides on the one-way clutch are facing upward.

    2. B007RVT

      Using a screwdriver, install the snap ring.

    3. B007V7Q

      While turning the one-way clutch inner race counter clockwise, install the one-way clutch inner race to the rear planetary gear.

  6. INSPECT 1 WAY CLUTCH NO.2


    1. B007U5EE01

      Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.

  7. INSTALL REAR PLANETARY RING GEAR


    1. B007Q6X

      Install the rear planetary gear onto the rear planetary ring gear.

  8. INSTALL PLANETARY OUTPUT SHAFT OIL SEAL RING


    1. B007S6S

      Coat the oil seal ring with ATF, and install it to the output shaft.

      Note

      Do not over-spread the ring ends.

      Tech Tips

      After installing the oil seal ring, check that it rotates smoothly.

  9. INSTALL REAR PLANETARY GEAR ASSEMBLY


    1. B007W45

      Install the output shaft into the rear planetary gear assembly.