SFI SYSTEM(w/o Canister Pump Module) PRECAUTION
INITIALIZATION
Note:If the ECM is replaced, register the ECU communication ID for Immobiliser System (w/o Entry and Start System).
Click hereClick hereClick hereClick hereClick hereClick here
Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle with motor body components.
Perform Registration (VIN registration) when replacing the ECM.
Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
Click hereClick hereClick hereClick hereClick hereClick here
Tip:Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.
WHEN USING GTS
CAUTION:Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.
IGNITION SWITCH EXPRESSIONS
Tip:The type of ignition switch used on this model differs depending on the specifications of the vehicle.
The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Switch (Condition)
Ignition switch off
LOCK
Off (Lock)
Ignition switch ACC
ACC
On (ACC)
Ignition switch ON
ON
On (IG)
Engine Start
START
On (Start)
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note:After the ignition switch is turned off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.