CRANKSHAFT POSITION SENSOR (w/o EGR Cooler) INSTALLATION


  1. INSTALL CRANK SHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the sensor.

    2. Install the sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
      A01DZC3

    3. Install the 3 clips and connect the sensor connector.

      Note

      Insert the crankshaft position sensor wire harness into the protrusions of the timing gear cover as shown in the illustration.

  2. INSTALL NO. 2 ENGINE UNDER COVER

  3. INSTALL NO. 1 ENGINE UNDER COVER

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  5. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.