MULTI-DISPLAY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL MULTI-DISPLAY ASSEMBLY


    1. B0069QM

      Connect each connectors and attach the clamp.

    2. Move the multi-display assembly as shown in the illustration

      B006DFKC01
      B006DHE Install in this Direction - -

    3. Attach the clip to install the multi-display assembly.

      B006F40C02
      B006DHE Install in this Direction - -

      Note

      Do not subject the multi-display assembly to excessive force or damage it.

    4. Install the 2 bolts.

      B006CRV

  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  3. INSTALL INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  6. INSTALL LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

    Click here

  7. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  8. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  12. INSPECT SRS WARNING LIGHT

    Click here