BRAKE FLUID REPLACEMENT

CAUTION / NOTICE / HINT

Note:

  • for Manual Transaxle:

    Move the shift lever to neutral and apply the parking brake before replacing the brake fluid.

  • for Multi-mode Manual Transaxle:

    Move the shift lever to N and apply the parking brake before replacing the brake fluid.

  • Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.

  • If brake fluid leaks onto any painted surface, immediately wash it off.

Tip:

If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.

PROCEDURE

  1. REMOVE CENTER NO. 1 COWL TOP VENTILATOR LOUVER

    1. C302725

      Disengage the 2 claws, 5 guides and remove the center No. 1 cowl top ventilator louver.

      Note:

      Do not damage the washer hose.

  2. FILL RESERVOIR WITH BRAKE FLUID

    1. C302726

      Remove the brake master cylinder reservoir filler cap.

    2. Fill the reservoir with brake fluid.

      Brake Fluid

      SAE J1703 or FMVSS No. 116 DOT3

      SAE J1704 or FMVSS No. 116 DOT4

      Note:

      • Do not remove the filter from the brake master cylinder reservoir and be sure to fill the brake master cylinder reservoir with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

      • Make sure that there is sufficient brake fluid in the reservoir.

  3. BLEED BRAKE LINE

    Note:

    • Bleed the brake line of the wheel farthest from the brake master cylinder sub-assembly first.

    • Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brake lines.

    1. Connect a vinyl tube to the bleeder plug.

    2. Depress the brake pedal several times, and then loosen the bleeder plug with the brake pedal depressed.*1

    3. When brake fluid stops coming out, tighten the bleeder plug and release the brake pedal.*2

    4. Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and new brake fluid comes out.

    5. Tighten the bleeder plug completely.

      6.5 N*m

      66 kgf*cm

      58 in.*lbf

    6. Repeat the above steps to replace the brake fluid of the brake lines for each wheel.

  4. INSPECT FOR BRAKE FLUID LEAK

  5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here

  6. INSTALL CENTER NO. 1 COWL TOP VENTILATOR LOUVER

    1. Engage the 5 guides and 2 claws to install the center No. 1 cowl top ventilator louver.