REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

    1. Attach the 8 claws to install the rear door belt moulding.

  2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click hereClick here

  3. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click hereClick here

  4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click hereClick here

  5. INSTALL REAR DOOR GLASS RUN LH

    Click hereClick here

  6. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click hereClick here

  7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click hereClick here

  8. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click hereClick here

  9. INSTALL DOOR ASSIST GRIP COVER LH

    Click hereClick here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click hereClick here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  12. CHECK POWER WINDOW CONTROL SYSTEM

    1. w/ Jam Prptection Function:

      Click hereClick here

    2. w/o Jam Prptection Function:

      Click here