SRS REAR SEAT CUSHION AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SEAT CUSHION AIRBAG ASSEMBLY LH


    1. B006A8E

      Install the rear seat cushion airbag assembly LH with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:


      • Do not reuse the nut.

      • If the installation surface or surrounding area of the rear seat cushion airbag assembly LH is deformed or damaged, replace the rear seat cushion panel LH with a new one.

    2. B006DA9

      Attach the claw to connect the airbag connector.

    3. Attach the wire harness clamp.

    4. B006CBA

      Install the 2 clips.

  2. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here