PANORAMIC VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the panoramic view monitor system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT
  2. CUSTOMER PROBLEM ANALYSIS


    1. Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

      Tech Tips

      The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.

      Problem Symptom Cause
      The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced. The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.
      Result
      Proceed to
      NEXT

    NEXT
  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

      Result
      Proceed to
      NEXT

    NEXT
  4. SYSTEM CHECK


    1. Check the vehicle specification.

      Result
      Result Proceed to
      w/ Navigation System A
      w/ Audio and Visual System B

    B
    A
  5. CHECK NAVIGATION SYSTEM


    1. Refer to the navigation system.

      Click here

      Result
      Result Proceed to
      Navigation system is normal A
      Navigation system is abnormal B

    A
    B
  6. CHECK AUDIO AND VISUAL SYSTEM


    1. Refer to the audio and visual system.

      Click here

      OK
      Audio and visual system is normal.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  7. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN DTCs are not output A
      CAN DTCs are output B

    B
    A
  8. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here


      Chassis > Panoramic View Monitor > Trouble Codes
      Chassis > Parking Assist Camera > Trouble Codes
    2. Clear the DTCs.

      Click here


      Chassis > Panoramic View Monitor > Clear DTCs
      Chassis > Parking Assist Camera > Clear DTCs
    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Click here


      Chassis > Panoramic View Monitor > Trouble Codes
      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B
    A
  9. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B
    A
  10. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test

      Click here

    2. Terminals of ECU

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  11. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT
  12. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT