VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1433

DTC Code DTC Name
C1433 Steering Angle Sensor Internal Circuit

DESCRIPTION

Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1433

Steering Angle Sensor Internal Circuit

Either condition is met:

  1. With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor for 0.012 seconds.

  2. An open in the sensor power supply circuit for 1 second or more.

Steering angle sensor (Spiral cable sub-assembly)

WIRING DIAGRAM

Refer to DTC C1432 (Click here).

CAUTION / NOTICE / HINT

Tip:

  • When DTC U0073, U0123, U0124 and/or U0126 is output together with DTC C1433, inspect and repair the trouble areas indicated by DTC U0073, U0123, U0124 and/or U0126 first (Click here).

  • When any of the speed sensors or the yaw rate and acceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor first, and then inspect and repair the steering angle sensor.

PROCEDURE

  1. CHECK DTC (CAN COMMUNICATION SYSTEM)

    1. Check for DTCs.

      Click hereClick here

      Chassis > ABS/VSC/TRC > Trouble Codes

      Result

      Result

      Proceed to

      CAN DTC is not output

      A

      CAN DTC is output

      B
    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

    Click here

    A

  2. REPLACE SPIRAL CABLE SUB-ASSEMBLY

    1. Replace the spiral cable sub-assembly.

      Click here

      Note:

      • Do not remove the steering angle sensor from the spiral cable sub-assembly.

      • When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.

      Result

      Result

      NEXT
    NEXT

    END