FRONT BUMPER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System

Click here

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B0085DU

      Remove the 5 clips.

    2. B0086VWC01
      B00847Z Remove in this Direction (1)
      B008776 Remove in this Direction (2)

      Disengage the guide and remove the cool air intake duct seal as shown in the illustration.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. B0088N0C01
      B0087TV Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. B0085GLC01
      *a Protective Tape
      B0089GN Insert Screwdriver Here
      B00847Z Remove in this Direction

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. B0086FN

      Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B0088M6

      Remove the 8 screws.

    5. B0087V6C01
      B0089GN Place Hand Here
      B00847Z Remove in this Direction

      Disengage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. B0086I4C01
      *A w/ Pre-collision System
      *B w/ Blind Spot Monitor System
      *C w/ TOYOTA Parking Assist-sensor System

      w/ Pre-collision System:


      1. Disconnect the connector.

    7. w/ Blind Spot Monitor System:


      1. Disconnect the connector.

    8. w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the connector.

    9. B0086Y2

      Remove the 2 clips.

    10. Remove the 4 bolts.

    11. B0088G2C01
      B00847Z Remove in this Direction

      Disengage the 2 claws and 2 guides to remove the front bumper assembly as shown in the illustration.

    12. w/ Fog Light:


      1. Disconnect the connector.

    13. B0089L1

      w/ Headlight Cleaner System:


      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.