REAR LIGHT ASSEMBLY INSPECTION

PROCEDURE

1. INSPECT REAR LIGHT ASSEMBLY LH

   1. 

      *a	Component without harness connected (Rear Light assembly LH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition	Specified Condition
      Battery positive (+) → U24-1 (B) Battery negative (-) → U24-2 (E)	Taillight illuminates

      If the result is not as specified, replace the rear light assembly LH.

2. INSPECT REAR LIGHT ASSEMBLY RH

   1. 

      *a	Component without harness connected (Rear Light assembly RH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition	Specified Condition
      Battery positive (+) → U25-1 (B) Battery negative (-) → U25-2 (E)	Taillight illuminates

      If the result is not as specified, replace the rear light assembly RH.