FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE

  1. REMOVE FRONT WHEEL RH

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  4. REMOVE REAR ENGINE UNDER COVER RH

    Click hereClick hereClick here

  5. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click hereClick hereClick here

  6. REMOVE V-RIBBED BELT

    Click here

  7. REMOVE CRANKSHAFT PULLEY

    1. A289823C02

      *a

      Turn

      *b

      Hold

      Using SST, hold the crankshaft pulley in place and loosen the pulley bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      09213-58014

      91551-80840

      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      09213-54015

      09330-00021

      Tip:

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A234912C03

      *a

      Turn

      *b

      Hold

      Using SST, remove the crankshaft pulley and pulley bolt.

      09950-50013

      09951-05010

      09952-05010

      09953-05020

      09954-05021

      Tip:

      If necessary, remove the crankshaft pulley and pulley bolt using SST.

  8. REMOVE TIMING CHAIN COVER OIL SEAL

    1. Using a knife, cut off the lip of the timing chain cover oil seal.

    2. A297325C01

      *a

      Protective Tape

      *b

      Cut Position

      Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain cover oil seal.

      Note:

      After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.