COMBINATION METER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE INTEGRATION CONTROL AND PANEL

    Click here

  9. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

    Click here

  10. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  11. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  12. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  13. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  14. REMOVE COMBINATION METER SUB-ASSEMBLY


    1. B005Z5VE03
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas shown in the illustration.

    2. B005ZAT

      Remove the 4 screws.

    3. B005XW0

      Move the combination meter sub-assembly as shown in the illustration.

    4. Disengage the clamp.

    5. Disconnect each connector to remove the combination meter sub-assembly.