HARD DISK DRIVE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    • A hard disk drive (HDD) is built into the navigation receiver assembly to store map and other data and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE INTEGRATION CONTROL AND PANEL

    Click here

  9. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

    Click here

  10. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  11. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

    Click here

  12. REMOVE NO. 2 RADIO RECEIVER BRACKET

    Tech Tips

    Use the same procedure as for the No. 1 radio receiver bracket Click here.

  13. REMOVE HARD DISK DRIVE


    1. A005A1O

      Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. A005CQX

      Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.