STEERING ANGLE SENSOR (w/ VSC) REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE NO. 2 STEERING COLUMN LOWER COVER (w/ Smart Entry and Start System)


    1. B007V1S

      Detach the 4 claws and remove the No. 2 steering column lower cover.

  6. REMOVE LOWER STEERING COLUMN COVER


    1. B007V1S

      Detach the 4 claws and remove the No. 2 steering column lower cover.

  7. REMOVE UPPER STEERING COLUMN COVER


    1. B007Q3XE01
      Text in Illustration
      *a Front of Vehicle
      *b Raise the backside of the steering column upper cover
      *c Pull diagonally backwards so that the claw of the steering column upper cover does not break

      Remove the steering column upper cover from the steering column assembly.

      Note

      If the steering column upper cover is removed by pulling it directly upwards, the claw may become damaged.

  8. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

    • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.


    1. B007QGGE01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral with sensor cable sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect each connector from the spiral with sensor cable sub-assembly.

    3. B007T8R

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.