AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DTC Code DTC Name
Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.

WIRING DIAGRAM

E228888E06

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - NO. 1 STEREO JACK ADAPTER)

    1. Disconnect the H115 radio receiver assembly connector.

    2. Disconnect the H104 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      H115-2 - H104-1

      Always

      Below 1 Ω

      H115-3 - H104-3

      H115-2 - Body ground

      Always

      10 kΩ or higher

      H115-3 - Body ground

      H115-5 - Body ground

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    (Click here)

    REPAIR OR REPLACE HARNESS OR CONNECTOR