STEERING KNUCKLE(for 2WD) INSTALLATION
CAUTION / NOTICE / HINT
Tech Tips
-
The following procedure is for the LH side.
-
Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
PROCEDURE
-
INSTALL DISC BRAKE AIR GUIDE PLATE
-
INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
-
CONNECT STEERING KNUCKLE LH
-
TEMPORARILY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
-
TEMPORARILY TIGHTEN FRONT PNEUMATIC CYLINDER ASSEMBLY WITH SHOCK ABSORBER LH (w/ Air Suspension)
-
TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
-
CONNECT FRONT STABILIZER LINK ASSEMBLY LH
-
TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
-
CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
-
CONNECT TIE ROD ASSEMBLY LH
-
INSTALL FRONT DISC BRAKE DUST COVER LH
-
INSPECT FRONT AXLE HUB BEARING LOOSENESS
-
INSPECT FRONT AXLE HUB RUNOUT
-
INSTALL FRONT DISC LH
-
for 6-Pot Caliper
-
except 6-Pot Caliper
-
-
CONNECT DISC BRAKE CYLINDER ASSEMBLY
-
CONNECT FRONT SKID CONTROL SENSOR WIRE
-
STABILIZE SUSPENSION
-
FULLY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
-
FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
-
FULLY TIGHTEN FRONT PNEUMATIC CYLINDER ASSEMBLY WITH SHOCK ABSORBER LH (w/ Air Suspension)
-
FULLY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
-
INSTALL REAR LOWER ARM MOUNTING REINFORCEMENT SUB-ASSEMBLY LH
-
INSTALL ENGINE SIDE COVER LH
-
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
-
INSTALL FRONT WHEEL
-
CONNECT BRAKE BOOSTER PUMP CONNECTOR (w/o Vacuum Brake Booster)
-
CHECK FOR SPEED SENSOR SIGNAL
-
w/ Vacuum Brake Booster:
-
w/o Vacuum Brake Booster:
-
-
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
-
INSPECT AND ADJUST VEHICLE HEIGHT (w/ Air Suspension)
-
PERFORM INITIALIZATION
Parking support brake system Panoramic view monitor system Parking assist monitor system Automatic headlight beam level control system -
ADJUST HEADLIGHT AIMING