TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) Back Sonar Sensor LH Circuit
| DTC Code | DTC Name |
|---|---|
| Back Sonar Sensor LH Circuit |
DESCRIPTION
The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.
WIRING DIAGRAM
PROCEDURE
INSPECT NO. 3 ULTRASONIC SENSOR (REAR CENTER SENSOR LH)
-
Remove the No. 3 ultrasonic sensor (rear center sensor LH).
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
1 (BI) - 5 (EI)
Always
10 kΩ or higher
1 (BI) - 2 (BO)
Always
10 kΩ or higher
3 (SI) - 4 (SO)
Always
Below 1 Ω
5 (EI) - 6 (EO)
Always
Below 1 Ω
Result
Proceed to
OK
NG
-
CHECK HARNESS AND CONNECTOR (REAR CENTER SENSOR LH - REAR CORNER SENSOR LH)
Disconnect the S3 No. 3 ultrasonic sensor (rear center sensor LH) connector.
Disconnect the S4 No. 3 ultrasonic sensor (rear corner sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
S3-3 (SI) - S4-4 (SO)
Always
Below 1 Ω
S3-1 (BI) - S4-2 (BO)
Always
Below 1 Ω
S3-5 (EI) - S4-6 (EO)
Always
Below 1 Ω
S3-3 (SI) - Body ground
Always
10 kΩ or higher
S3-1 (BI) - Body ground
Always
10 kΩ or higher
S3-5 (EI) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR