EXHAUST PIPE INSTALLATION

PROCEDURE

  1. INSTALL AIR FUEL RATIO SENSOR

    Click here

  2. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    1. Check the free length of the compression spring.

      1. A128853

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length

        41.5 mm (1.63 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. A291393C01

      *1

      Gasket

      *2

      Wooden Block

      Using a hammer and wooden block, tap on a new gasket until its surface is flush with the exhaust manifold converter sub-assembly.

      Note:

      • Install the gasket in the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket by dropping it, etc.

      • Do not damage the outer surface of the gasket.

      • Do not push on the gasket with the front exhaust pipe assembly when connecting it.

    3. Connect the front exhaust pipe assembly to the 3 exhaust pipe supports.

    4. Install the front exhaust pipe assembly and 2 compression springs with the 2 bolts.

      43 N*m

      438 kgf*cm

      32 ft.*lbf

  3. INSTALL TAILPIPE ASSEMBLY

    1. Check the free length of the compression spring.

      1. A128853

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length

        38.5 mm (1.52 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. A291393C01

      *1

      Gasket

      *2

      Wooden Block

      Using a hammer and wooden block, tap on a new gasket until its surface is flush with the front exhaust pipe assembly.

      Note:

      • Install the gasket in the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket by dropping it, etc.

      • Do not damage the outer surface of the gasket.

      • Do not push on the gasket with the tailpipe assembly when connecting it.

    3. Connect the tailpipe assembly to the 2 exhaust pipe supports.

    4. Install the tailpipe assembly and 2 compression springs with the 2 bolts.

      43 N*m

      438 kgf*cm

      32 ft.*lbf

  4. INSPECT FOR EXHAUST GAS LEAK

    1. Check that there are no exhaust gas leaks from the points (connection areas of the exhaust pipes and installation areas of each sensor).