REAR WIPER MOTOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE CENTER BACK DOOR GARNISH

    Click here

  4. REMOVE BACK DOOR SIDE GARNISH LH

    Click here

  5. REMOVE BACK DOOR SIDE GARNISH RH

    Click here

  6. REMOVE BACK DOOR INSIDE HANDLE

    Click here

  7. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  8. REMOVE REAR WIPER ARM

    1. E184727

      Open the wiper arm head cap.

    2. E184728

      Remove the nut and rear wiper arm.

  9. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY

    1. E184729

      Disconnect the connector.

    2. Remove the 3 bolts and rear wiper motor and bracket assembly.

  10. REMOVE REAR WIPER MOTOR GROMMET

    1. E184730

      Remove the wiper motor grommet.