AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Voice Guidance does not Function

WIRING DIAGRAM

B004F6JE09
*1 (Shielded)
*2 Navigation ECU
*3 Radio Receiver Assembly

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the navigation ECU, always replace it with a new one. If a navigation ECU which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The navigation ECU may not operate normally.

PROCEDURE


  1. CHECK VOICE GUIDANCE SETTING


    1. Check that the voice guidance settings are not off.

      OK
      Voice guidance settings are not off.
      Result
      Proceed to
      OK
      NG

    NG

    CHANGE THE VOICE GUIDANCE SETTINGS TO ON

    OK

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the O148 radio receiver assembly connector.

    2. Disconnect the O150 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O148-22 (SI+) - O150-6 (VOI+) Always Below 1 Ω
      O148-23 (SI-) - O150-7 (VOI-) Always Below 1 Ω
      O148-22 (SI+) or O150-6 (VOI+) - Body ground Always 10 kΩ or higher
      O148-23 (SI-) or O150-7 (VOI-) - Body ground Always 10 kΩ or higher
      O150-8 (SLD1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK AUDIO FUNCTION


    1. Check that sound can be heard from a front speaker.

      OK
      Sound can be heard.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE NAVIGATION ECU Click here

    NG

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here