TRANSMISSION WIRE REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL LH

    Click here

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  6. REMOVE FRONT FENDER APRON SEAL LH

    Click here

  7. DRAIN AUTOMATIC TRANSAXLE FLUID


    1. B008574

      Remove the refill plug and gasket from the automatic transaxle case sub-assembly.

    2. B0085UC

      Using a 10 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle housing.

    3. B0085WSC01
      *1 No. 1 Transmission Oil Filler Tube

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle housing and drain the automatic transaxle fluid.

    4. Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle housing.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

    5. Using a 10 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the transaxle housing.

      Tech Tips

      Reuse the old gasket as the overflow plug will be removed again to adjust the automatic transaxle fluid level.

    6. Temporarily install the gasket and refill plug to avoid automatic transaxle fluid spillage.

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the automatic transaxle fluid level.

  8. REMOVE VACUUM SWITCHING VALVE (for Active Control Engine Mount System)

    Click here

  9. REMOVE FRONT ENGINE MOUNTING INSULATOR

    Click here

  10. REMOVE FRONT SUSPENSION MEMBER DYNAMIC DAMPER

    Click here

  11. SEPARATE OIL COOLER UNION SUB-ASSEMBLY


    1. B00845IC01
      *1 Oil Cooler Union Bolt

      Remove the bolt to separate the oil cooler union sub-assembly bracket portion from the automatic transaxle case sub-assembly.

    2. Remove the oil cooler union bolt and 2 gaskets to separate the oil cooler union sub-assembly from the automatic transaxle case sub-assembly.

  12. REMOVE TRANSMISSION CASE SIDE COVER


    1. B0085W0

      Remove the 10 bolts and transmission case side cover from the automatic transaxle case sub-assembly.

  13. REMOVE TRANSMISSION WIRE


    1. B0085IE

      Disengage the claw, rotate the lever and disconnect the transmission wire connector.

    2. B0087T3C01
      *a Connector (A)
      *b Connector (B)

      Disengage the clamp to disconnect the transmission wire from the solenoid lock plate.

    3. Disconnect the 9 solenoid valve connectors.

      Tech Tips


      • Using a screwdriver, disconnect the solenoid valve connector (A) using the procedure shown in the illustration.

      • Using a screwdriver, disconnect the solenoid valve connector (B) using the procedure shown in the illustration.

    4. B00864Z

      Remove the bolt and temperature sensor clamp and disconnect the temperature sensor from the transmission valve body assembly.

    5. B0084L1

      Disconnect the transmission revolution sensor (NT) connector and transmission revolution sensor (NC) connector.

    6. B00860M

      Remove the bolt and transmission wire from the automatic transaxle case sub-assembly.