INTAKE AIR CONTROL VALVE ACTUATOR(for TCV) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake air control valve actuator (for TCV) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic view monitor system

Click here


  • Replacement of throttle body assembly

  • Cleaning the deposits from the throttle body assembly

  • Replacement of fuel injector assembly

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)


    1. B0086S3

      Remove the 2 bolts and intake air control valve actuator (for TCV) from the intake manifold.

      Note


      • B00899K

        Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or intake air control valve actuator (for TCV) at the locations marked by the circles in the illustration.

      • B00858C

        Do not loosen or remove the bolt or 2 nuts shown in the illustration.

    2. Remove the gasket from the intake air control valve actuator (for TCV).