TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE

1. REMOVE NO. 1 ENGINE COVER

   Click hereClick hereClick here

2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click hereClick hereClick here

4. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

   Tip:

   • After the floor shift lever assembly or the transmission control cable assembly is replaced, be sure to adjust the transmission control cable assembly.

   • If the shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position, or if it is possible to move the shift lever to the reverse position without pulling up the slider shaft, the length of the transmission control cable assembly must be adjusted.

   1. Remove the rear console box assembly.

      • for Hatchback, Wagon:

        Click hereClick here

      • for Sedan:

        Click hereClick here

   2. 

      Remove the clip and disconnect the transmission control select cable from the floor shift lever assembly.

   3. 

      *a	Lock Piece
      *b	Stopper
      *c	Adjuster Case
      *d	Twist the stopper
      *e	Pull Out
      *f	Return the stopper

      Release the lock of the transmission control select cable length adjustment structure.

      1. Twist the stopper.

      2. Pull the lock piece outward from the adjuster case to release the lock.

      3. Return the stopper.

   4. 

      Connect the transmission control select cable to the floor shift lever assembly and install the clip.

      Note:

      • Make sure that the lock piece of the transmission control select cable length adjustment structure is facing upward when the transmission control select cable is connected.

      • Make sure that the transmission control select cable is securely installed.

   5. 

      *1	Outer Lever
      *2	Reverse Restrict Pin Assembly
      *a	Secured

      Hook the outer lever of the manual transaxle assembly to the reverse restrict pin assembly to secure it.

   6. 

      *a	Slider Shaft
      *b	Cam Wall

      Push the slider shaft against the cam wall.

      Note:

      • Do not pull up the slider shaft.

      • When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.

   7. Lock the transmission control select cable length adjustment structure.

      

      *a	Lock Piece	*b	Stopper
      *c	Adjuster Case	*d	Twist the stopper
      *e	Push	*f	Return the stopper

      1. Twist the stopper.

      2. Push the lock piece into the adjuster case with slider held against the cam wall.

         Note:

         • Securely press in the lock piece until the lock engages.

         • When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.

      3. Return the stopper to prevent the lock from being released.

         Note:

         • Push the lock piece as far as it will go.

         • Confirm whether the transmission control select cable length adjustment structure is locked securely.

   8. 

      *1	Outer Lever
      *2	Reverse Restrict Pin Assembly
      *a	Released

      Move the shift lever to the reverse position, so that the outer lever can be released.

   9. Install the rear console box assembly.

      • for Hatchback, Wagon:

        Click hereClick here

      • for Sedan:

        Click hereClick here

5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

   Click hereClick hereClick here

6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

   Click here

7. INSTALL NO. 1 ENGINE COVER

   Click hereClick hereClick here