CAMERA HEATER REMOVAL

PROCEDURE

  1. REMOVE PRE-CRASH SAFETY CITY SENSOR

    Click here

  2. REMOVE PRE-CRASH SAFETY CITY HEATER WIRE

    1. Disconnect the connector.

    2. E367504

      Disengage the 2 clamps.

    3. E367505

      Disconnect the 2 connectors to remove the pre-crash safety city heater wire.

  3. REMOVE PRE-CRASH SAFETY CITY HEATER

    Tip:

    • Perform this step only when replacement of the pre-crash safety city heater is necessary, because it is a non-reusable part.

    • If the pre-crash safety city heater has been removed, replace it with a new one.

    1. If the ambient temperature is lower than 15°C:

      1. Using a heat light, heat the pre-crash safety city heater and windshield glass surface.

        Table 1. Heating Temperature

        Item

        Temperature

        Pre-crash safety city heater

        15 to 80°C (59 to 176°F)

        Windshield glass

        15 to 80°C (59 to 176°F)
        CAUTION:

        • Do not touch the heat light and heated parts, touching the heat light may result in burns.

        • Touching heated parts for a long time may result in burns.

        Note:

        Do not heat the pre-crash safety city heater or windshield glass excessively.

    2. E367506

      Using a plier, and remove the pre-crash safety city heater as shown in the illustration.