KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   1. 

      Connect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

   2. Install the airbag assembly with the 4 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click hereClick here

3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

   Click hereClick here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click hereClick here

5. INSTALL COWL SIDE TRIM BOARD LH

   Click hereClick here

6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

   Click hereClick here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

8. CHECK SRS WARNING LIGHT

   1. Check the SRS warning light (Click here).