WIPER AND WASHER SYSTEM PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:

    System

    See Procedure

    Stop and Start System

    Click here

    Simple Intelligent Parking Assist System

    Power Door Lock Control System

  2. IGNITION SWITCH EXPRESSIONS

    1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch (Position)

      Engine Switch (Condition)

      Ignition Switch off

      LOCK

      Off (Lock)

      Ignition Switch ACC

      ACC

      On (ACC)

      Ignition Switch ON

      ON

      On (IG)

      Engine Start

      START

      On (Start)

  3. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

    1. Do not clean or adjust the washer nozzle with a safety pin, etc. because:

      1. The washer nozzle tip is made of resin and could be damaged.

      2. Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

        Click here

    2. If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.