ECM REMOVAL

PROCEDURE

1. PERFORM REGISTRATION

   Click here

2. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick here

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   1. 

      Disconnect the mass air flow meter connector and detach the wire harness clamp.

   2. Detach the 2 clamps.

   3. Loosen the hose clamp and remove the air cleaner cap sub-assembly.

5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   1. 

      Remove the 3 bolts and air cleaner case sub-assembly.

7. REMOVE ECM

   1. 

      	Push
      	Raise

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note:

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

   2. 

      Detach the claw and disconnect the relay.

   3. Remove the 3 bolts and ECM.

      Note:

      Avoid physical shock to the ECM.

   4. 

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

   5. 

      Remove the 2 screws and No. 2 ECM bracket from the ECM.