HEADLIGHT LEVELING SWITCH INSPECTION

PROCEDURE

  1. INSPECT HEADLIGHT LEVELING SWITCH

    1. Check the voltage.

      1. E230293C01

        *a

        Component without harness connected

        (Headlight Leveling Switch)

        Connect the positive (+) lead from the battery to terminal 1 (B) and the negative (-) lead to terminal 4 (E).

      2. Measure the voltage according to the value(s) in the table below.

        Standard Voltage Ratio

        Tester Connection

        Switch Position

        Specified Condition

        (Battery voltage is 12 V)

        1 (B) - 2 (T)

        0

        0.84 to 1.56 V

        (0.5)

        1.8 to 2.52 V

        1

        2.76 to 3.48 V

        (1.5)

        3.72 to 4.44 V

        2

        4.68 to 5.4 V

        (2.5)

        5.64 to 6.36 V

        3

        6.6 to 7.32 V

        (3.5)

        7.56 to 8.28 V

        4

        8.52 to 9.24 V

        (4.5)

        9.48 to 10.2 V

        5

        10.44 to 11.16 V

        If the result is not as specified, replace the headlight leveling switch.

    2. E230293C02

      *a

      Component without harness connected

      (Headlight Leveling Switch)

      Illumination Inspection.

      1. Apply battery voltage to the connector and check the illumination condition.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → Terminal 3 (ILL+)

        Battery negative (-) → Terminal 4 (E)

        Illuminates

        If the result is not as specified, replace the headlight leveling switch.